77
9
SCAN OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
■ Memory scan
IMPORTANT!: To perform memory scan, 2 or more mem-
ory channels MUST be programmed, otherwise the scan
will not start.
qPush [MR/S.MW] to select memory mode.
wSet the squelch level.
eWhile pushing and holding [2/SCAN], rotate [DIAL] to se-
lect the desired scanning type.
•“ALL” for full memory scan; “BAND” for band memory scan,
“MODE” for mode scan, “DUP” for duplex scan.
rRelease [2/SCAN] to start the selected scan.
• Scan pauses when a signal is received.
• Rotate [DIAL] to change the scanning direction, or resumes
manually.
tTo stop the scan, push [VFO/MHz].
Duplex scan function: Repeatedly scans two frequencies
(transmission/reception) during duplex scan operation.
To Next Page
Loading...
