79
9
SCAN OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
■ Skip channel/frequency setting
Memory channels can be set to be skipped for memory skip
scan. In addition, memory channels can be set to be skipped
for both memory skip scan and frequency skip scan. These
are useful to speed up the scan interval.
qSelect a memory channel:
➥ Push [MR/S.MW] to select memory mode.
➥ Rotate [DIAL] to select the desired channel to be a skip
channel/frequency.
wPush and hold [MR/S.MW] for 1 sec. to enter select mem-
ory write mode.
ePush [2/SCAN](
∫∫
) or [8/TS](
√√
) several times to select
“SKIP.”
rRotate [DIAL] to select the skip condition from “SKIP,” “P
SKIP” or “OFF” for the selected channel.
• P SKIP: The channel is skipped during memory/bank scan and
the programmed frequency is skipped during VFO scan,
such as programmed scan.
• SKIP : The channel is skipped during memory or bank scan.
• OFF : The channel or programmed frequency is scanned dur-
ing any scan.
(Continue to the next page.)
To Next Page
Loading...
