52
7 DV MODE OPERATION (Optional UT-121 is required for IC-91A)
■ Message operation
DD
TX message programming
TX messages are available for up to 6 channels and each
channel can be programmed with a message of up to 20
characters. Available characters are 0 to 9, A to Z
(capital let-
ters), a to z (small letters), some symbols and space.
A TX message channel “Ch01” must be programmed, if you
want to use the GPS message. The GPS message is trans-
mitted from Ch01 only.
qEnter “TX MESSAGE” in message/position set mode.
• TX MESSAGE screen is displayed.
wRotate [DIAL]
†
to select the desired transmit message
channel.
• Ch01 to Ch06 and OFF are available.
• Previously message is displayed if programmed.
ePush [6/M.N](
≈≈
) to select the message edit condition.
• The 1st digit of the message blinks.
rRotate [DIAL]
†
to select the desired character or symbol.
• Push [3/LOW](A/a) to change the character group from “AB” (al-
phabetical characters; capital letters), “ab” (alphabetical charac-
ters; small letters), “12” (numbers) and “ !”” (symbols) in
sequence.
• If un-necessary character is entered, push [6/M.N](
≈≈
) or
[4/DUP](
ΩΩ
) to select the character, then push [1/SCOPE](CLR)
to erase the selected character, or push and hold
[1/SCOPE](CLR) for 1 sec. to erase following all characters from
the cursor.
tPush [6/M.N](
≈≈
) to select 2nd digit, then rotate [DIAL]
†
to
select the desired character or code.
• Push [6/M.N](
≈≈
) to move the cursor right; push [4/DUP](
ΩΩ
) to
move the cursor left.
• 2nd digit blinks (1st digit stops blinking).
yRepeat the steps r and t to enter the desired message.
• Up to 20-character message can be set.
uPush [5/SKIP](ï) to store the message.
iPush [MENU/LOCK] to return to frequency indication.
To Next Page
Loading...
