Why Icom Transceiver cannot transmit distress calls?
If you're unable to transmit distress calls with your Icom Transceiver, the MMSI (DSC self ID) code might not be programmed. Program the MMSI (DSC self ID) code to enable distress call transmission.
General| Brand | Icom |
|---|---|
| Model | IC-M323 |
| Category | Transceiver |
| Language | English |
Details distress call procedure using Channel 16.
Explains how to calculate the Maximum Permissible Exposure radius.
Step-by-step guide to inputting the Maritime Mobile Service Identity code.
Procedures for operating the transceiver for communication.
Managing individual and group DSC addresses.
Manual input of ship's position and UTC time for distress calls.
Step-by-step guide to initiating a distress call.
How to make a DSC call to a specific station.
How to make a DSC call to a specific group.
How to broadcast a message to all ships.
Requesting the position of a specific ship.
Announcing your ship's position to another vessel.
Checking if a specific vessel is in the communication area.
Handling distress relay calls and their acknowledgements.
Procedures for handling incoming individual DSC calls.
Handling incoming group, area, or all ships DSC calls.
Procedures for handling incoming position request calls.
Procedures for handling incoming position report calls.
Handling incoming polling requests and test calls.
To Next Page
