EasyManua.ls Logo

Icom IC-M801E - Test Call Procedures

Icom IC-M801E
80 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
28
7
CALL PROCEDURE
2001 NEW 2001 NEW
Test call
Testing on the exclusive DSC distress and safety call-
ing frequencies (such as 2187.5 kHz) should be
avoided as much as possible by using other methods.
When testing on the distress/safety frequency is un-
avoidable, it should be indicated that these are test
transmissions.
Normally the test call would require no further commu-
nications between the two stations involved.
q Push [MODE
SET
] to select the DSC menu.
w Rotate [CH] to select “Test” call, then push
[ENT].
e Select the desired coast station code, then push
[ENT],
Use [CH] to select the coast station code when pre-pro-
grammed.
When “Manual set” is selected, enter the desired
code (last 7 digits only) via the keypad.
-The first 2 digits “00 (double zero)” are fixed for the
coast station code.
r Select the desired call frequency, then push [ENT].
Use [CH] to select one of the desired distress/safety
frequencies.
When “Manual set” is selected, enter the desired
transmit and receive frequencies via the keypad.
t The calling stand-by screen is displayed as fol-
lows, verify the calling condition then push and
hold [CALL] for 1 sec. to transmit the test call.
y After sending a call, the transceiver waits for an ac-
knowledgement.
u When receiving an acknowledgement, the display
shows the received ID code, or ID name, if pro-
grammed.
************************
*
Test
ACK
*
*
ABC Port
*
************************
Exit
F1B
GPS
<
Wait
for
ACK
>
Test
Lat
34
34'N
Lon135
34'E
12:34
Exit
*********
Test
*********
---------
Call
---------
To:Port
ICOM
Category:Safety
Call
Freq:TX
2187.5kHz
RX
2187.5kHz
Call
*********
Test
*********
----
Call
frequency
----
TX:
2187.5kHz
RX:_2187.5kHz
OK
*********
Test
*********
----
Call
frequency
----
Manual
set
2187.5kHz
Ç
OKSEL
*********
Test
*********
------
Address
ID
------
00
______
OK
*********
Test
*********
------
Address
ID
------
Manual
set
Port
ICOM
001234567
Port
ABC
001234566
Port
M801
001234565
Ç
OKSEL
IC-M801E_0.qxd 05.12.2 16:32 Page 28

Table of Contents

Related product manuals