Icom IC-M801E

62
13
FREQUENCY PROGRAMMING
2001 NEW 2001 NEW
■ Programming a frequency
DD
Receive frequency
q Select the desired channel to be programmed.
• Channel 1 to 160 (maximum) are programmable.
w Push [RX CLAR ] to select the frequency selection
mode.
e Enter 4 to 6 digits of the desired frequency via the
keypad.
• Or rotate [GRP] and [CH] to change the frequency.
• Pushing [Y ]/[Z] on the microphone also tunes the fre-
quency.
r Push [MODE SET ] several times to select the de-
sired operating mode (type of emission).
t Push [ENT] for 1 sec. to program the user chan-
nel.
• 3 beeps sound and “≈” disappears.
0123
4A
CH
---GPS---
Lat
45 59'N
Lon134
44'E
16:23
RX J3E
SIMP
“Ç” indicator disappears when programming is completed.
0123
4A
CH
---GPS---
Lat
45 59'N
Lon134
44'E
16:23
RX J3E
SIMP
Ç
0123
4A
CH
---GPS---
Lat
45 59'N
Lon134
44'E
16:23
RX J3E
SIMP
Ç
“Ç” indicator appears.
DD
Transmit frequency
q Select the desired channel to be programmed.
w Push [TX TXF ].
e Enter the desired 5 or 6 digit frequency via the key-
pad.
• [GRP] and [CH], as well as [Y]/[Z] on the microphone
cannot be used.
r Push [ENT] for 1 sec. to program the user chan-
nel.
• 3 beeps sound.
0123
4A
CH
---GPS---
Lat
45 59'N
Lon134
44'E
16:23
RX J3E
SIMP
“ TX ” indicator disappears.
0123
4A
CH
---GPS---
Lat
45 59'N
Lon134
44'E
16:23
RX
TX
J3E
SIMP
0123
4A
CH
---GPS---
Lat
45 59'N
Lon134
44'E
16:23
TX
“ TX ” indicator blinks.
IC-M801E_0.qxd 05.12.2 16:33 Page 62