43
11
SET MODE
11
■ Initial set mode
Initial set mode operation is used for programming in-
frequently changed values, conditions or functions.
DD
Entering set mode
q Turn the power OFF, if the transceiver is powered
ON.
w While pushing [MODE
SET
], push [POWER] to turn
the power ON to enter initial set mode.
e Rotate [GRP] to select the desired item.
r Rotate [CH] to set the values or conditions for the
selected item.
t Turn the power OFF and ON again to exit set mode.
DD
Initial set mode items
NOTE: Selection of some of the set mode items de-
scribed here are not available on some transceiver
versions.
Number of user channels
This item sets the number of user channels. Up to
160 channels can be set. (default: 160)
FSK ITU channel selection
This item sets the capability of the ITU channels for
FSK from ON and OFF.
This item will not appear when ITU channels are in-
hibited. (default: ON)
***
SET
MODE
***
ITEM SEL
OFF
ON
ÇÇ
Automatic tune
When an optional automatic antenna tuner is con-
nected, tuning can be started automatically without
pushing [TUNE
THRU
], for instant operation.
If manual tuning is required, this automatic operation
can be deactivated.
(default: OFF)
***
SET
MODE
***
OFF
ON
ÇÇ
ITEM SEL
Scan type
This item selects one of the following scan functions.
Programmed scan searches signals within the fre-
quency range and activates slowly while squelch is
open and fast while squelch is closed.
Channel scan and channel resume scan searches 20
channels around a user selected channel, or
searches all ITU channels in the band when an ITU
channel is selected. (default: CH SCAN)
***
SET
MODE
***
CH
SCAN
CH-RESUME
SCAN
PROGRAM
SCAN
ÇÇ
ITEM SEL
IC-M801E_0.qxd 05.12.2 16:32 Page 43
To Next Page
Loading...
