Icom IC-M801E

40
10
DSC MENU OPERATION
2001 NEW
■ Verifying self-ID
➥ During setup select menu indication, rotate [CH] to
select “MMSI check” then push [ENT] to dis-
play the programmed MMSI ID (self-ID).
➥ Push [DSC] to select DSC watch mode.
➥ Push [MODE
SET ] to select DSC menu.
➥ Rotate [CH] to select “Set up” then push [ENT].
•Push [MODE
SET ] to return to DSC watch mode, or
push [FREQ/CH] to return to the select screen.
******** Set up ********
------
MMSI check ------
ID:123456789
OK
Cancel
■ Telephone number input
q During DSC menu indication, rotate [CH] to select
“Set up” then push [ENT] to select setup menu.
• The select screen is displayed.
w Rotate [CH] to select the “Number,” then push
[ENT].
• The telephone number list screen is displayed.
• 10 telephone number memories are available.
e Rotate [CH] to select “<add>” then push [ENT].
•The call/traffic/scan frequency setup screen is dis-
played.
r Push the numeral keys to input the desired 10-
character telephone number name, and telephone
number, then push [ENT].
• Rotate [CH] to move the cursor.
******** Set up ********
--------
Number --------
Name:
† _________
Number:________________
OK
Cancel
******** Set up ********
--------
Number --------
<add>
Test1
1234567890123456
Test2
6543210987654321
SEL
OK
Ç
Cancel
■ Self testing
According to regulations, the IC-M801E has a self test-
ing capability to check the internal AFSK encoder and
decoder circuits without signal transmission via the
transceiver.
q During DSC watch mode, push [MODE set] to se-
lect DSC menu.
w Rotate [CH] to select “Self test” then push
[ENT] to start the self test.
e “OK” is displayed when both encoder and decoder
functioning correctly.
If the circuit has a problem, the following message
is displayed.
• Both or either message is/are displayed depending on
problem.
DSC-RX NG : DSC receiver’s decoder circuit has a
problem.
TRANSC NG : Transceiver’s encoder or decoder
circuit has a problem.
****** Self test *******
DSC-RX
NG
TRANSC
NG
OK
Cancel
****** Self test *******
OK
OK
Cancel
****** Self test *******
Testing...
OK
Cancel
IC-M801E_0.qxd 05.12.2 16:32 Page 40