Icom ID-52A PLUS - Operating in the Access Point Mode

4
Access Point mode operation
23
■ Operating in the Access Point mode
You can operate the Access Point transceiver as described below in the Access Point mode.
What you can do while in the Terminal mode
Display the RX HISTORY screen. Hold down [CD] for 1 second.
Turn the Monitor function ON or OFF
Push [SQL].
L Rotate [DIAL] while pushing [SQL] to adjust the squelch level.
A weaker signal than the set squelch level is not transmitted
through the Internet.
Open the MENU screen. Push [MENU].
Turn the Key Lock function ON or OFF. Hold down [LOCK] for 1 second.
Open the Quick Menu*. Push [QUICK].
Audibly announce the displayed Call Sign.
Hold down [SPCH] for 1 second.
L Hold down [QUICK] for 1 second when using the
ID-31A PLUS/ID-31E PLUS.
Select 1 MHz or 10 MHz tuning steps.
Push [VFO/MHz].
L Push [V/MHz] when using the ID-31A PLUS/ID-31E PLUS/
ID-51A (PLUS2)/ID-51E (PLUS2)/ID-50A/ID-50E.
L You cannot select 10 MHz tuning steps in the
ID-31A PLUS/ID-31E PLUS/ID-52A/ID-52E/ID-50A/ID-50E/
ID-52A PLUS/ID-52E PLUS.
Select the transmit output power.
Hold down [LOW] for 1 second to select the transmit
output power between S-Low, Low1, Low2, Mid, and High.
L Hold down [LO] for 1 second to open the Select Output Power
window when using the ID-52A/ID-52E/ID-50A/ID-50E/
ID-52A PLUS/ID-52E PLUS.
L No icon appears when high power is selected.
L “SLO,” “LO1,” “LO2,” or “MID” appears when S-low, Low 1,
Low 2, or Mid power is selected.
Adjust the audio volume level. Rotate [VOL].
Select an operating frequency. Rotate [DIAL].
Turn the transceiver ON or OFF.
Hold down [
] for 1 second.
L The Access Point mode is not automatically canceled even if
you turn OFF the transceiver, then ON it again.
* You can select the following items (Quick Menu) in
the Access Point mode.
<<Normal Mode>>
Band Select*
1
TS
ATT*
1,2,3
GPS Information
GPS Position
Home CH Set
Voltage
<<REC Start>>
<<GPS Logger Only>>
*
1
“Band Select” and “ATT” are not displayed when using
the ID-31A PLUS/ID-31E PLUS.
*
2
“ATT” is not displayed when using the
ID-51A (PLUS2)/ID-51E (PLUS2).
*
3
Not displayed when using the Access Point mode on
the B band.
TIP: See the transceiver’s manual about each key
operation.
ID-31A PLUS/ID-31E PLUS
Basic manual Section 2, 3, 11
Advanced manual Section 11
ID-51A (PLUS2)/ID-51E (PLUS2)
Basic manual Section 2, 4, 6
Advanced manual Section 9
ID-52A/ID-52E/ID-50A/ID-50E/
ID-52A PLUS/ID-52E PLUS
Basic manual Section 2, 3, D-STAR OPERATION
Advanced manual Section 5