Icom ID-52A PLUS - Preparation; Entering Your Call Sign in the RS-MS3 W or RS-MS3 A; Dwhen Operating in the Terminal Mode

1
Preparation
5
■ Entering your call sign in the RS-MS3W or RS-MS3A
DWhen operating in the Terminal mode:
IMPORTANT:
• Register your own call sign (MY) at a gateway server.*
• Register the Terminal/AP call sign that is set in the RS-MS3A or RS-MS3W to the RS-RP3C as the access point.*
* Ask the gateway repeater administrator for details.
1. Open the RS-MS3W or RS-MS3A on your Windows or Android device.
2. Enter the connected transceiver’s My Call Sign in “Terminal/AP Call sign.”
L Information
• The Terminal Call sign should be 8 characters. Enter spaces between MY Call Sign and the 8th character.
• Enter a unique ID suffix between A and Z, except for G, I, and S, at the end of MY Call Sign for the 8th character.
• Call signs shown below are just examples.
Transceiver
MY Call Sign:
JA3YUA
Windows device
Enter “JA3YUA A” in
“Terminal/AP Call sign” in
the RS-MS3W.
InternetInternet
When using a Windows device:
When using an Android device:
InternetInternet
Transceiver
MY Call Sign:
JA3YUA
Android device
Enter “JA3YUA A” in
“Terminal/AP Call sign” in
the RS-MS3A.
Other station
Other station
NOTE for your own Call Sign on the Terminal mode (ID-52A PLUS/ID-52E PLUS only):
You can set your own call sign in terminal mode. ([MENU] > SET > My Station > My Call Sign (TM))
L As the default, “Same as Normal DV” is selected. ([MENU] > SET > My Station > My Call Sign)
L If you edit My Call Sign (TM), your own call sign will also be changed.