Icom ID-52A PLUS - Dwhen Operating in the Access Point Mode

1
Preparation
6
■ Entering your call sign in the RS-MS3W or RS-MS3A
DWhen operating in the Access Point mode:
IMPORTANT:
• Register your call sign (MY) at a gateway server.*
• Register the Terminal/AP call sign that is set in the RS-MS3A or RS-MS3W to the RS-RP3C as the access
point.*
* Ask the gateway repeater administrator for details.
1. Open the RS-MS3W or RS-MS3A on your Windows or Android device.
2. Enter your Access Point (AP) transceiver’s My Call Sign in “Terminal/AP Call sign.”
L Information
• The AP Call sign should be 8 characters. Enter spaces between MY Call Sign and the 8th character.
• Enter a unique ID suffix between A and Z, except for G, I, and S, at the end of the Access Point transceiver’s
MY Call Sign for the 8th character.
• Call signs shown below are just examples.
Remote D-STAR
transceiver*
MY Call Sign: JA3YUA
Access point transceiver
MY Call Sign: JL3YRP
InternetInternet
Windows device
Enter “JL3YRP D” in
“Terminal/AP Call sign”
in the RS-MS3W.
Access point
When using a Windows device:
When using an Android device:
Remote D-STAR
transceiver*
MY Call Sign: JA3YUA
* Any model as long as the transceiver is D-STAR capable.
Only one D-STAR transceiver can access the Access Point at the same time.
Access point transceiver
MY Call Sign: JL3YRP
Access point
Android device
Enter “JL3YRP D” in
“Terminal/AP Call sign”
in the RS-MS3A.
InternetInternet
Other station
Other station