4
Access Point mode operation
27
■ Making a Gateway call through the Access point transceiver
D When using the DR function (Continued)
2. Set the Access Point using the DR function
Set the Access Point registered in Procedure 1
( 1. Register the Access Point information to the
Repeater List) to “FROM.”
3. Set “TO” and transmit
1. Set “TO” destination.
(Example: Hamacho 430)
L You can select the “Local CQ,” but cannot make a
call.
2. Hold down [PTT] to transmit.
3. Release [PTT] to receive.
L If you cannot receive a reply, see page 34 to read
the tips to solve the problem.
To Next Page
Loading...
