Icom rs-ba1 - Step 3: Before Configuration

Installtion guide A
A-6
Step3. Before conguration
To congure the remote control system, the following settings are required.
D Firewall setting (RS-BA1 Instruction Manual p. 1)
To let the Remote Utility work properly, it must be added as an exception in the Firewall. See the RS-BA1
Instruction Manual for details.
D Volume adjustment for your audio devices (RS-BA1 Instruction Manual p. 6)
Before you start communicating using the RS-BA1, the PC’s audio volume must be set to a proper level.
When your PC is used as a Base station, adjust the audio level of the device that is connected to your radio.
When your PC is used as a Remote station, adjust the audio level of the device that your microphone, speaker,
or headset is connected to.
D To allow access from the Internet (RS-BA1 Instruction Manual p. 12)
If you congure the remote control system through the Internet, you need to congure your Base station and
Remote station routers to allow access from the Internet.
Congure the port forwarding settings, and IP lter settings on your router, for port numbers 50001, 50002, and
50003 which are used for the Remote Utility.
See your router’s manual for details of how to congure the settings.
See the RS-BA1 Instruction Manual (“1. BEFORE USING REMOTE CONTROL SYSTEM” section) for details.
1. 2. Step3. 4. 5. 6.