26 PRT-CTRL-SE Protege SE Integrated System Controller Installation Manual | June 2017
6.3 Trouble Zones
Each Controller can monitor up to 64 local trouble zones. Trouble zones are used to monitor the status of the
Controller and in most cases are not physically connected to an external zone. For example, trouble zone
CP001:03 is used to monitor the Controller's backup battery voltage and warn the Controller that the battery is
disconnected or voltage is too low. This can then be used to report a message to a monitoring station, remote
computer, keypad or siren.
The following table details the trouble zones that are configured in the Controller. The trouble type and group
define the trouble that is generated by the trouble zone when it is activated.
Zone Number Description Type Group
CP001:01 Module Tamper System Tamper System
CP001:02 AC Failure Power Fault General
CP001:03 Low Battery Power Fault General
CP001:04 Real Time Clock Not Set RTC/Clock Loss General
CP001:05 Service Report Test * *
CP001:06 Service Report Failure to Communicate Reporting Failure General
CP001:07 Phone Line Fault Phone Line Lost General
CP001:08 Auxiliary Failure Power Fault General
CP001:09 Bell 1 Cut/Tamper Bell/PGM Fault General
CP001:10 Bell 2 Cut/Tamper Bell/PGM Fault General
CP001:11 Bell 1 Cut/Tamper Bell/PGM Fault General
CP001:12 Bell 2 Cut/Tamper Bell/PGM Fault General
CP001:13 Module Communication Module Loss System
CP001:14 Module Network Security Module Security System
CP001:15 Expansion Device Missing Hardware Fault System
CP001:16 Communication Port 1 Fault Hardware Fault System
CP001:17 Communication Port 2 Fault Hardware Fault System
CP001:18 Ethernet Hardware Fault Hardware Fault System
CP001:19 Ethernet Link Lost Hardware Fault System
CP001:20 DVAC Line Fault/Polling Error Hardware Fault System
CP001:21 ModBUS Communication Fault Hardware Fault System
CP001:22 Protege System Remote Access Hardware Fault System
CP001:23 Installer Logged In Hardware Fault System
CP001:24 Service 1 Stopped Hardware Fault System
CP001:25 Service 2 Stopped Hardware Fault System
CP001:26 Service 3 Stopped Hardware Fault System
CP001:27 Service 4 Stopped Hardware Fault System
CP001:28 Reserved * *
| | | | | | | |
CP001:64 Reserved * *
To Next Page
Loading...
