ICT Protege SE - Mechanical and System Specifications; Mechanical Diagrams and Layout

PRT-CTRL-SE Protege SE Integrated System Controller Installation Manual | June 2017 33
10 Mechanical Diagram
The mechanical diagram shown below outlines the essential details needed to help ensure the correct
installation of the Protege Controller.
16V AC Input
Isolated COMMS
350mA/700mA Jumper
EOL Jumper
Cabinet Tamper Input
Bell/Siren Outputs
PGM 3/4 Outputs
Zones 1 to 4
Fault/Status LED
Zones 5 to 8
Zones 9 to 12
Reader Port 1
Reader Port 2Zones 13 to 16
RS-485 Network
Telephone Dialer
Config Switch
10/100 Ethernet
Ethernet Status LEDs
Expansion Interface
Part Numbe
r
Mounng Holes
Baery Input
Coin Cell Baery
Mechanical Diagram