4 PRT-CTRL-SE Protege SE Integrated System Controller Installation Manual | June 2017
8 Hardware Configuration ___________________________________________________ 29
8.1 Configuration Switch ................................................................................................... 29
8.2 Defaulting a Controller ................................................................................................. 30
9 LED Indicators ___________________________________________________________ 31
9.1 Status LED ................................................................................................................... 31
9.2 Fault Indicator .............................................................................................................. 31
9.3 Charge/Test Indicator .................................................................................................. 31
9.4 Auxiliary OK Indicators ................................................................................................ 31
9.5 AC OK Indicator .......................................................................................................... 31
9.6 5V Isolated Power Indicator ........................................................................................ 31
9.7 Bell 1/Bell 2 Indicators ................................................................................................. 32
9.8 Network RX/TX Indicators ........................................................................................... 32
9.9 Ethernet Link Indicator ................................................................................................ 32
9.10 100Mb Indicator .......................................................................................................... 32
9.11 R1/R2 Data Indicators ................................................................................................. 32
9.12 Online Indicator ........................................................................................................... 32
10 Mechanical Diagram ______________________________________________________ 33
11 Mechanical Layout _______________________________________________________ 34
12 System Capacities ________________________________________________________ 35
13 Technical Specifications ___________________________________________________ 37
13.1 Current and Validation Example 1 ............................................................................... 38
13.2 Current and Validation Example 2 ............................................................................... 39
13.3 Maximum Total Output Current: UL and ULC Installations ......................................... 39
13.4 Current and Validation (UL Installation) Example 1 ..................................................... 40
13.5 Current and Validation (UL Installation) Example 2 ..................................................... 41
14 New Zealand and Australia ________________________________________________ 43
15 European Standards ______________________________________________________ 44
16 UL and ULC Installation Requirements ______________________________________ 46
16.1 Central Station Signal Receiver Compatibility List ...................................................... 46
16.2 ULC Compliance Requirements .................................................................................. 46
CAN/ULC-S304-06 ...................................................................................................... 46
CAN/ULC-S319-05 ...................................................................................................... 49
CAN/ULC-S559-04 ...................................................................................................... 49
16.3 UL Compliance Requirements .................................................................................... 53
UL1610 ........................................................................................................................ 53
To Next Page
Loading...
