Ideal Boilers LOGIC Code Combi 26 - Page 20

20
INSTALLATION
Ideal Logic Code Combi - Installation and Servicing

18 FLUE EXTENSION DUCTS - Fortotaluelengthsgreaterthan575mm
Pack D Flue extension duct kit contents
Flue duct support
Flue support cutting aid
(shown folded up)
Wall plugs - 4 off
Extension duct & clamp
1.0m (39") long
No. 10 x2" wood screw - 4 off
nm8732
17 SETTING THE FLUE - SIDE Wall thicknesses of 148 to 378mm
Notes.
a. If using the extension ducts go to Frame 18.
b. For shorter ue requirements use non telescopic B Pack.
1. 
2. Measure distance from side of boiler to inside of wall and

3. 

4. 

5. 
6. 
nm8945
L + 115
Drill hole
Adhere sealing tape
Measurement to be
taken from this point
NON TELESCOPIC FLUE - Wall thickness of 115mm to 440mm
TELESCOPIC FLUE - Wall thickness of 150mm to 375mm
Notes.
If using the extension ducts go to Frame 18.
1. 
2. 

3. 

4. Cut the inner tube to a length 20mm longer to aid
engagement, using the cutting aid provided
Measure from
this
RING
3G9675
206279-1.indd 20 06/01/2011 09:10:03