IDEC FC6A-C16K1CE User Manual

FC6A S ERIES M ICRO S MART A LL - IN -O NE T YPE C OMMUNICATION M ANUAL FC9Y-B1730 3-1
3: COMMUNICATION SETTINGS
Introduction
This chapter describes how to configure the settings to use the communication functions of the FC6A Series MicroSmart and
examples of using these functions.
For functions that require advanced setup including the communication ports and network settings, first configure those settings in
the Function Area Settings dialog box in WindLDR, and then download the user program to the FC6A Series MicroSmart.
For the way to configure settings related to CAN J1939 communication, see "J1939 Communication" on page 8-1.
Setting List
Function Name Overview Reference Setup Location
Communication ports
Configures the communication function, parameters and the ports to match
the communication device.
3-2
Function area
settings
Network settings
Configures information for connecting the FC6A Series MicroSmart to a
network.
3-3
Network Management Configures SNTP settings and the PING instruction timeout time. 3-8
Connection settings
Communication mode and parameters for the Ethernet communication can be
configured for each connection so that the FC6A Series MicroSmart can
communicate with other network devices over the Ethernet.
3-11
Remote host list
The remote host devices on the network that the FC6A Series MicroSmart
communicates with can be registered and managed in the Remote Host List.
3-16
Remote host list
Auto Ping Function
Configures the auto ping function to monitor the network connection status of
remote hosts.
3-18

IDEC FC6A-C16K1CE Specifications

General

Brand	IDEC
Model	FC6A-C16K1CE
Category	Control Unit
Language	English