Idemia MorphoWave SP - Pre-Installation Checks and Tools

28
MorphoWave Compact - 2018_2000035853-v81
3.1 > Before proceeding to the installation
Make sure that you have all the components described in “Components of the initial package” section
at your disposal.
Remove the wall plate. Keep this element at hand.
Figure 7: Removing wall frame
It is then possible to fix the terminal on the wall.
For an optimal use, the terminal must be installed in an area where the lighting conditions
are controlled. Avoid direct exposure of the sensor to the sun light and ensure good ambient
lighting for face detection if used.