Idemia MorphoWave SP - Step by Step Procedure

30
MorphoWave Compact - 2018_2000035853-v81
3.3 > Step by step procedure
1050
to 1150
mm
Floor
Wall
40 min
Figure 8: Side view
The recommended height for fixing of the terminal is 1.05 to 1.15 m (height of the acquisition glass).
For an optimal use, the terminal must be installed in an area where the lighting conditions
are controlled. Avoid direct exposure of the sensor to the sun light.
Power supply from electrical source shall be switched off before starting the installation.
The strength of the attachment depends on the solidity of the wall on which the terminal is
mounted.