MorphoWave Compact - 2018_2000035853-v81
PoE+ (Power over Ethernet Plus)
MorphoWave SP terminal's power supply can also be provided by the Ethernet using RJ45 connection
(Power over Ethernet Plus mode - IEEE802.3at type 2 compliant).
The terminal may be powered via a UL 294B PSE PoE+ Limited power source (IEEE802.3at type 2
compliant).
If several terminals are powered through the same PoE+ switch, make sure the switch is
capable of providing enough power to each device (30W).
Some functions are available ONLY with an external power supply and not with PoE+:
Wi-Fi
™
. External DC power is required for these features.
Please refer to “Using PoE+” recommendations section 6 / for more details about the best practices for
powering the MorphoWave SP terminals with PoE+.
To Next Page
Loading...
