xii Installation, Support, and Maintenance Guide
Evolution X7 Satellite Router
About
Document Conventions
This section illustrates and describes the conventions used throughout this document.
cd /etc/snmp/
WARNING: A Warning highlights an essential operating or maintenance
procedure, practice, condition, or statement which, if not strictly observed,
could result in injury, death, or long term health hazards.
CAUTION: A Caution highlights an essential operating or maintenance procedure,
practice, condition, or statement which, if not strictly observed, could result in
damage to, or destruction of, equipment or a condition that adversely affects
system operation.
NOTE: A Note is a statement or other notification that adds, emphasizes, or
clarifies essential information of special importance or interest.
Related Documents
The following documents are available at http://tac.idirect.net. Consult these documents for
information about installing and using iDirect’s satellite network software and equipment.
• iDX iBuilder User Guide
• iDX iMonitor User Guide
• Web iSite User Guide
• iDX Satellite Router Installation and Commissioning Guide
Convention Description Example
Command Used when the user is required to
enter a command at a command
line prompt or in a console.
Enter the command:
Terminal
Output
Used when showing resulting
output from a command that was
entered at a command line or on a
console.
crc report all
8350.3235 : DATA CRC [ 1]
8350.3502 : DATA CRC [5818]
8350.4382 : DATA CRC [ 20]
Screen
Reference
Used when referring to text that
appears on the screen on a
Graphical User Interface (GUI).
Used when specifying names of
commands, menus, folders, tabs,
dialogs, list boxes, and options.
1. To add a remote to an inroute group, right-click
the Inroute Group and select Add Remote.
The Remote dialog box has a number of user-
selectable tabs across the top. The Information
tab is visible when the dialog box opens.
Hyperlink Used to show all hyperlinked text
within a document or external
links such as web page URLs.
For instructions on adding a line card to the
network tree, see Adding a Line Card on
page 108.
To Next Page
Loading...
