Installation, Support, and Maintenance Guide 45
Evolution X7 Satellite Router
Appendix F X7 Reset
The X7 Router has three types of reset functions: Level 0, Level 1, and Level 2. Each type has
a different effect on the router. Contact the iDirect TAC center for more information.
F.1 Level 0 Reset
Level 0 reset provides a basic reset function.
NOTE: Level 0 reset can be triggered in 3 ways: by powering up the X7 Router;
briefly pressing the reset button; or, in Web iSite selecting File Management >
Restart Device > Restart.
Level 0 reset features:
• Initiated by:
• Router powering up
• Briefly pressing the reset button and not keeping it pressed for more than 1
second, see Section 3.3, X7 Router Rear Panel Description on page 10 for the
reset button location
• In Web iSite, select the File Management menu > Restart Device > Restart
• Used to boot to a newly-loaded software image and configuration
• Recovery: initiate a Level 0 reset
• Router rear LEDs: RX1 PWR LED turns green; RX2 PWR LED and BUC PWR LED go off
F.2 Level 1 Reset
Level 1 reset is used to run hardware diagnostics and validate router hardware.
NOTE: Debug diagnostics are triggered by this reset. If router hardware requires
diagnostics and validations call the iDirect TAC center. Exit and recover from a
Level 1 reset by briefly pressing, for less than 1 second, the reset button.
• Recovery: initiate a Level 0 reset
• Router rear LED conditions when pressing reset for Level 1 reset, see Table 3-3 on page 11
for LED descriptions: RX1 PWR LED turns green when the reset button is initially pressed,
then goes off; RX2 PWR and BUC PWR LED go off, initially; after pressing the reset button
for 1 second, the RX2 PWR LED turns green, then goes off
To Next Page
Loading...
