42 Installation, Support, and Maintenance Guide
Evolution X7 Satellite Router
Figure E-1. DC-DC Power Supply Assembly at a Glance
DC-DC Power Supply Assembly at a Glance
Table E-2. Power Module Power Cable Installation Instructions Detail
Step Instructions Diagram
1. Strip approximately 1/4 inch of insulation
from the ends of three appropriately sized
(14-18 AWG) DC input wires.
2. Loosen the three screws on the terminal
block plug . Insert DC (-), DC (+), and
ground wires into the corresponding
terminals of the DC terminal block plug.
Fasten the three screws securely. Do not
over-tighten.
3. Insert the cable tie through one of the
holes in the right half of the strain relief
clip.
To Next Page
Loading...
