Table 5-2. Removing and/or Replacing the Power Module
• Make sure power cord is unplugged
• Unscrew chassis screw
• Pull firmly but gently on the handle pull of the power supply
to extract the power module from the slot
• Slide in power supply
• Make sure the power supply is securely pushed in and flush
• Tighten screw
• Plug power cord into power supply input receptacle
22 Installation, Support, and Maintenance Guide
Evolution X7 Satellite Router
Repacking the X7 Router
5.5 Repacking the X7 Router
If the X7 Router system is damaged or if the chassis needs to be moved to another location,
the unit needs to be repacked in the original shipping boxes.
To repack the system:
1. Disconnect all cables.
2. Place the X7 Router inside the original foam cutout in the shipping box.
3. Properly seal the box with packing tape.
For warranty service, obtain a Return Material Authorization (RMA) number from the reseller
or iDirect prior to shipping. Direct customers of iDirect, may contact the iDirect TAC directly
to obtain an RMA number and shipping instructions. Follow the shipping instructions,
complete the RMA form, and attach the form to the outside of the shipping box.
Event Steps to Take
Removing the Power Module
Replacing the Power Module
To Next Page
Loading...
