Installation, Support, and Maintenance Guide 9
Evolution X7 Satellite Router
X7 Front Panel LED Status Descriptions
iDX Release Notes for details. Figure 3-1 on page 8 shows the front panel and Table 3-2
describes the front panel LED color and status information:
Table 3-2. X7 Router iDX 3.2 LED Descriptions
Label Signal Color/Type Definition
POWER Indicates power supply status and any power-
related problems
Off No or low power input
Green Valid power input detected
Yellow Problem with BUC voltage selection
STATUS Indicates basic operational state and problems
with core hardware
Off Powered off or going through initial Power-on Self-
test (POST)
1 second flashing Green Initial POST failed
Green HW operation is normal (all self-tests passed)
Red Fault: hardware, software, one or more self-test
failures, or configuration error
FAN Provides fan status
Green All fans working
Red Failure of one or more fans
TEMP Indicates problems with the current operating
temperature
Off Router OFF or booting if STATUS LED is not Green
Green Normal operating temperature
Yellow Operating temperature is nearing the over-temp
or under-temp threshold
Red Operating temperature has exceeded the over-
temp or under-temp threshold
RX1 and RX2 Provides downstream receive status, RX2 is
reserved for future use
Off Receiver off or not configured
Yellow Downstream carrier configured, demodulator not
yet locked
1 second flashing Yellow Downstream carrier configured, demodulator
locked to downstream carrier, Network Clock
Reference (NCR) not yet locked
Green Downstream carrier configured, demodulator and
NCR locked to downstream carrier
To Next Page
Loading...
