Installation, Support, and Maintenance Guide 27
Evolution X7 Satellite Router
Appendix B Safety
Follow the safety guidelines in this chapter during installation of the Evolution X7 Satellite
Router. These guidelines help to protect the X7 Router from potential damage and help to
ensure personal safety. Keep this safety information handy for reference.
Read this entire chapter before installing or using the X7 Router. Adhere to all warnings listed
on the product warning labels and in the operating instructions.
This chapter contains the following sections:
• Section B.1, Installation Guidelines on page 27
• Section B.2, Electrical Safety on page 28
• Section B.3, Physical and Environmental Considerations on page 29
B.1 Installation Guidelines
When installing the X7 Router, observe all caution and warning statements. Follow all the
warnings and cautions in this section for personal safety and to protect the equipment. These
guidelines are not intended to cover all of the hazardous situations that may be encountered
during installation. Follow all facility and local safety guidelines.
The installation of the X7 Router must comply with the applicable national and local electrical
codes for the United States and Canada, as follows:
• In the United States, the National Fire Protection Association (NFPA) 70, United States
National Electric Code
• In Canada, the Canadian Electric Code, Part 1, CC22.1
• In other countries, the International Electromechanical Commission (IEC)
Recommendation 364, part 1 through part 7
• All cables (IFL, LAN, and other cables) that run from the outdoor equipment to the indoor
equipment must be connected to a surge protector at the point of entry to the building
• Lightning protection should be installed to protect the X7 Router unit as appropriate for
local conditions and per local codes
To Next Page
Loading...
