IFM IO-Link master-PROFINET AL1102 - LR DEVICE Configuration

IO-Link Master with PROFINET Interface StandardLine 8 Ports IP 65 / IP 66 / IP 67
24
>
9.1 LR DEVICE
Content
Remarks .................................................................................................................................................25
IoT: Configure access rights ...................................................................................................................26
IoT: Configure the interface to the LR SMARTOBSERVER ..................................................................27
Fieldbus: Set PROFINET interface ........................................................................................................27
IO-Link ports: Activate data transfer to the LR SMARTOBSERVER ....................................................28
IO-Link ports: Configure operating mode ...............................................................................................29
IO-Link ports: Set the device validation and data storage ......................................................................30
Firmware: Reset device to factory settings ............................................................................................31
Firmware: Reboot the device..................................................................................................................31
Configure IO-Link devices ......................................................................................................................32
33692
On delivery, the AL1102 is configured with the factory settings (→ Factory settings (→ S. 43)).
Required software: LR DEVICE (1.4.0.x or higher) (art.-no.: QA0011/QA0012)