IFM SD1540 - Page 31

31
UK
Explanation submenu MEM
Parameter Explanation and setting options
Lo�F Minimum value of the flow value measured in the process (flow volume or
flow velocity)
Hi�F Maximum value of the flow value measured in the process (flow volume
or flow velocity)
Lo�T Minimum value of the temperature measured in the process
Hi�T Maximum value of the temperature measured in the process
Lo�P Minimum value of the pressure measured in the process
Hi�P Maximum value of the pressure measured in the process
Explanation submenu DIS
Parameter Explanation and setting options
diS�L standard process value display
L1 = current process value for volumetric flow
L2�Temp = current process value for flow and temperature
L2�Pres = current process value for volumetric flow and pressure
L2�Totl = current process value for volumetric flow and totaliser
L3�TP = current process value for volumetric flow and temperature and
pressure
L4 = current process value for volumetric flow and temperature and
pressure and current totaliser value
diS�U update rate of display
d1 = high
d2 = medium
d3 = low
diS�R display rotation: 0°, 90°, 180°, 270°
diS�B display brightness: 25 %, 50 %, 75 %, 100 %, OFF (measured value
display in the RUN mode switched off)