35
UK
The parameters can also be set via the IO-Link interface�
Special feature for parameter setting via IO-Link:
Enter SP, rP, FH, FL, ASP, AEP for volume flow monitoring in % of the
final value of the measuring range and transmit the parameter setting to
the device�
> The unit internally converts the percentage values into absolute num-
transmits the calculated value back to the parameter setting software
after re-reading of the unit�
Functions which can only be set via the IO-Link interface: �
10.1 Parameter setting in general
1� Change from the RUN mode to the main menu [
]
2� Select the requested parameter [▲] or [▼]
3� Change to the setting mode [
]
4� Change the parameter value [▲] or [▼] > 1 s
5� Acknowledge the set parameter value [
]
6� Return to the RUN mode > 30 seconds (timeout)
If [ Locked via Communication] is displayed when an attempt is made to
modify a parameter value, an IO-Link communication is active (temporary
locking)�
If [ Locked via system] is displayed, the sensor is permanently locked
via software� This locking can only be removed with a parameter setting
software�
10.1.1 Select submenu
1� Press [
] to change from the process value display to the main menu�
2�
]�
3�
]�
10.1.2 Change to the process value display (RUN mode)
There are 2 possibilities:
To Next Page
Loading...
