30
Test
Pressing the “Test” soft key from this menu will allow you to access the Parameter
Review screen. For specific instructions for reviewing and editing test parameters,
refer to section 4.3. Test Parameters.
System
Pressing the “System” soft key from this menu will allow you to access the Setup
System screen. For specific instructions for editing system parameters, refer to
section 4.2. System Setup.
4.2. System Setup
1. From the Perform Tests screen, press the “Menu” soft key. The Main Menu
screen will now be displayed.
2. From the Main Menu screen, press the “Menu” soft key. Results, Test and System
selections will now be displayed.
3. From this screen, press the “System” soft key. The Setup System Menu will now
be displayed.
From the Setup System screen, fourteen different hardware and software controls
may be accessed: PLC Remote, Single Step, Alarm, Contrast, Results, Lock, Mem
Lock, Smart GFI, Cal-Alert, Cal Date, Cal Due, Alert, Date and Time. Pressing the
“Exit” soft key at any time will save all parameters and return to the Perform Tests
screen.
4.2.1. System Setup Soft Keys
Directional soft keys ,,
The “,, ” soft keys are used to scroll the cursor to the different system parameters.
+ key
The “+” soft key is used to increase numerical values or toggle settings ON and OFF.
Exit key
The “Exit” soft key is used to save the new system parameters and return to the
Perform Tests screen.
To Next Page
Loading...
Need help?
General