page 41
Sensitivity
Some applications may yield more consistent
results with less sensitivity.
Select: Max, High, Medium, Low
Factory Default=’Max’ (best for destructive tests)
1. Press and hold
MENU, then press ON/OFF to turn ON the
gauge and enter the Setup Menu. Press the down arrow key to
highlight Sensitivity, then press the right arrow key to select.
2. Press the up/down arrow keys to select and press
MENU to
input your selection.
3. Press the left arrow key until the door icon
# appears, then press
and hold
MENU two seconds to exit. Or press the left arrow
key and when ‘Exit Menu’ appears, press
MENU to exit.
3
11 REFERENCE SECTION — SETUP MENU 2/4
Setup Menu
+/- Indicator
# Sensitivity >
Zero/Tare Reset
Zero/Tare Reset
Select: All Reset or Peak Only
All Reset: zeroes and tares all values
Peak Only: zeroes the peak value without tare (see note below)
Factory Default=‘All Reset’
1. Press and hold
MENU, then press ON/OFF to turn ON the
gauge and enter the Setup Menu. Press the down arrow key to
highlight Zero Tare Reset, then press the right arrow key to select.
2. Press the up/down arrow keys to select and press
MENU to
input your selection.
3. Press the left arrow key until the door icon
# appears, then press
and hold
MENU two seconds to exit. Or press the left arrow
key and when ‘Exit Menu’ appears, press
MENU to exit.
Note:
All Reset: Press
ZERO to tare the weight of a preload or attach-
ment and zero the display.
Peak Only: Press
ZERO to zero the display without tare.
Press and hold
ZERO for two seconds to zero the weight of a pre-
load or attachment.
4
Setup Menu
Sensitivity
# Zero/Tare Reset >
Send Functions
To Next Page
Loading...
Need help?
General
