11 REFERENCE SECTION — PROGRAM MENU 4/6
Display Functions
Display Format Factory Default=‘Multi’
Single Display displays force value, unit, peak and
battery indicators.
Multi Display divides the screen into three sections.
Top section displays date, time, data storage, or +NG count.
Middle section displays unit and value.
Lower section displays peak, min/max, stored data, or high/low set-
points. See pages 32-33, Using Multi Display.
Select: Single or Multi
1. Turn ON the gauge, then press and hold
MENU two seconds to
enter the Program Menu. Press the down arrow key to highlight
Display Functions, then press the right arrow key to select.
2. Press the up/down arrow keys to highlight Display Format and
press the right arrow key to select.
3. Press the up/down arrow keys to select and press
MENU to
input your selection.
4. Press the left arrow key until the door icon
# appears, then press
and hold
MENU two seconds to exit. Or press the left arrow
key and when ‘Exit Menu’ appears, press
MENU to exit.
Brightness Factory Default=‘Power Save’
Select bright or power save.
1. Follow Display Format step 1 , above.
2. Press the up/down arrow keys to highlight Brightness and press
the right arrow key to select.
3. Press the up/down arrow keys to select and press
MENU to
input your selection.
4. Press the left arrow key until the door icon
# appears, then press
and hold
MENU two seconds to exit. Or press the left arrow
key and when ‘Exit Menu’ appears, press
MENU to exit.
6
page 37
Program Menu
Sound
# Display Functions >
Date and Time
To Next Page
Loading...
Need help?
General
