Immergas AUDAX PRO 4 V2 - General Warnings

4
GENERAL WARNINGS
• Carefully follow the precautions listed below as they are crucial to guarantee the safety of the product.
ATTENTION:
- always disconnect power to the condensing unit before performing maintenance on it or
accessing the components inside the unit.
- Make sure that installation and inspection operations are carried out by qualied personnel.
- ey must comply with the precautions and other important warnings to avoid seriously dam-
aging the system and injuring the users.
• Carefully read the content of this manual before installing the condensing unit and keep it in a safe place so that it can be referred
to aer installation.
• For greater safety, the installers should always read the following warnings with the utmost attention.
• Store the use and maintenance manual in a safe place and remember to hand it over to the new owner should the condensing unit
be sold or transferred.
• is manual explains how to install the condensing unit. Using other types of units with dierent control systems can damage the
units and invalidate the warranty. e manufacturer will not be held liable for damage resulting from improper use of the unit.
• e manufacturer cannot be held liable for damage resulting from unauthorised changes or improper connection of the electric and
hydraulic lines. Failure to comply with these instructions or with the requirements set forth in the “Operating limits” table, including
those in the manual, immediately invalidates the warranty.
• Failure to comply with the instructions indicated in the production specications immediately invalidates the warranty.
• Do not use the units if you notice any damage on them or if you perceive something strange, such as a loud noise or burnt smell.
• To prevent electrocution, re or injury, always switch o the unit, disable the protective switch and, if smoke escapes or if the unit is
extremely noisy, contact the Authorised Technical Service Centre.
• Remember to inspect the unit at regular intervals, including the electrical connections, the refrigerant pipes and the protections.
• ese operations must only be done by qualied personnel.
• e unit contains moving and electric parts which must always be kept out of the reach of children.
• Do not have unauthorised personnel attempt to repair, move, modify or reinstall the unit. ese operations could cause damage to
the product, electric shocks and re.
• Do not place liquid containers or other objects on the unit.
• All the materials used to manufacture and package the condensing unit are recyclable.
• e packaging material and the dead batteries of the remote control (optional) must be disposed of in compliance with local standards.
• e refrigerant in the condensing unit must be disposed of as special waste. At the end of its life, the condensing unit must be disposed
of in an Authorised Assistance Centre or returned to the shop so that it can be disposed of correctly and safely.
• Wear protective gloves to unpack, move, install and repair the unit so that its edges do not injure your hands.
• Do not touch the internal parts (water pipes, refrigerant pipes, heat exchanger, etc.) while the unit is operating. If it needs to be
adjusted, leave it as long as necessary to cool o and make sure to put on protective gloves.
• In case of refrigerant leaks, try not to come into contact with the refrigerant as this could cause serious injury.
• If the condensing unit is installed in a small room, consider adequate ventilation to avoid a leak level beyond the maximum allowed
limit. In that case, there is the risk of death by suocation.