Industrial Data Systems IDS 430 User Manual

IDS 430/433 Users Manual Version 1.0
- 21 -
REBUILD ID MEMORY: Press the ENTER key when the display prompts,
“rebuiLd”. The display then prompts “id”. Enter the numeric 0 then press ENTER
to rebuild ID memory.
COUNT UNUSED ID’S: Press the ENTER key when the display prompts
“Count”. The display prompts “FrExxx” where xxx is the number of unused ID
records in memory.
Set Beginning Sequence Number
Depress the number 9 key and then the ENTER key. The display prompts "reg 9"
for 1 second and then displays the current value. Press the CLEAR key if no
change is to be made, or enter a new value and then press the ENTER key. The
next sequence number printed will be the entered value +1.
Options
• Print key: Set parameter 52 = 4 (execute user function 4) to enable the print
key to print the weight on the scale. The print data is sent to Serial
Communications Port 1. If units other than lb are used, change print label 85
to the correct units. (This option is not available for printers that use the
parallel output port).
• Unit’s key: Set parameter 53 = 127 (execute Units function) if weighing of
dual units is required.
Notes
• The ID file maintenance functions are password level 1 protected. If a
password has been configured (function 64) the operator will be prompted for
the password before the file maintenance menu is displayed.
• ID memory is cleared to zero at power up unless CFG parameter 41 (battery
back up enable) is set to 1.

Industrial Data Systems IDS 430 Specifications

General

Brand	Industrial Data Systems
Model	IDS 430
Category	Measuring Instruments
Language	English