IDS440 Users Manual version 4.2 Set Operation Parameters
24
Parameter Functions
Fn. No Function Name Password Level
59 Display Calibration Audit Number 0
60 Calibrate Scale - Deadload first 3
61 Calibrate Scale - span first 3
62 Calibrate Deadload Only 3
63 Adjust Gain Calibration 3
64 Configure Passwords 2
65 Configure Print Formats 2
66 Set Time and Date 2
67 Display Operation Parameters 0
68 Print Operation Parameters 0
69 Diagnostic Tests 0
70 Initialize Operation Parameters to factory defaults. 3
71 Configure Event Monitor 2
72 Function Editor 2&3
73 Initialize Function Memory 2
74 Set Debug mode for Event monitors and Scale basic fns.
2
75 Enable Peak Detect (optional) 2
76 Set debug mode for event monitors and scale basic fns. 2
78 Erase Id Memory 1
79 Enable Multi-point Linearization (default = disabled[0])
3
80 Calibrate using Multi-point Linearization 3
81 Analog output offset (default = 0) 1
82 Analog output span (default = 10,000) 1
83 Analog output register (default = 0 [disabled]) 1
To Next Page
Loading...
Need help?
General