InfiNet Wireless R5000 Technical User Manual
Copyright © 2004-2010 by InfiNet Wireless
76
Three more parameters are available for management:
• “Bi-directional” check-box that allows choosing between making bi-
directional (when checked) and unidirectional (unchecked) performance
tests.
• “Use mint” check-box allows performing MINT-enabled test when all the
traffic and link parameters are controlled and managed by MINT
functions such as ATPC and autobitrate. In this mode the statistics for
errors abd retries is not available.
• “Test time” parameter allows setting the duration of the test for each
bitrate in seconds (5 seconds by default).
The bitrates list on the “Performance test” page consists of the bitrates that
corresponds to the channel bandwidth set on the unit (5/10/20/40MHz). To
perform the tests for the bitrates related to the other channel bandwidth you
need to reconfigure channel bandwidth (“Channel Width” parameter in the
“Radio Setting” section of the “Basic Settings” page) on both units that form the
tested link.
Bi-directional performance test output description for 180 Mbps bitrate (40MHz
channel bandwidth):
To Next Page
Loading...