InFocus IN3136a - Setting Up the Remote Control; Inserting Remote Control Batteries

— 9 —
SETUP AND OPERATION
Inserting the Remote Control Batteries
1.
Remove the battery compartment
cover by sliding the cover in the
direction of the arrow (A). Pull out the
cover (B).
2.
Insert a 3V lithium battery with the
positive side facing up.
3.
Replace the cover.
Caution:
1. Only use a 3V lithium battery (CR2025).
2. Dispose of used batteries according to local ordinance regulations.
3. Remove the battery when not using the projector for prolonged periods.
Note:
Batteries are not normally included with InFocus projectors.