X1 Service Guide 61
Power and Start-up Problems
The projector communicates its status via an LED located on the keypad. When this status LED is green,
you know that the projector is working properly. When the status LED is solid red or flashing red, you
know there are lamp, power or startup problems. The frequency with which the status indicator blinks red
indicates one of several error codes. These error codes provide crucial information about projector
malfunctions.
Go to the next page to begin the power diagnosis sequence.
Below is a table that shows the meaning the various LED states.
NOTE We strongly suggest that you follow the entire power diagnosis sequence, which begins on the
next page.
LED Status
LED flashes green
The projector is starting up after the Power button was pressed, or the
projector is shutting down after the Power button was pressed.
LED is solid green
The projector is ready to light the lamp when the Power button is
pressed. Or the lamp is lit and the projector is operating properly.
LED flashes red once The lamp will not strike after five tries (2 1/2 minutes).
LED flashes red two times
The lamp has more than 2,980 hours of use. Requires replacement.
Projector shuts down.
LED flashes red three times Lamp failure. Projector shuts down.
LED is solid red Undiagnosed error. Projector shuts down.
To Next Page
Loading...
Need help?
General
