X1 Service Guide 45
Remove and Replace the Lamphouse
The lamphouse (505-1514-xx) fastens to the bottom case. It provides an alignment mechanism for the
lamp module to ensure precise beam focus into the optical path.
The lamphouse includes the safety switch and thermal switch.
Two cooling fans fasten to the rear side of the lamphouse. If you need to replace a fan, refer to Remove
and Replace the Cooling Fans on page 27. If you're removing the lamphouse to access another FRU,
you don't need to remove the fans.
1. Remove the following items:
Lamp module (page 42)
Focus ring (page 30)
Zoom ring (page 30)
Front bezel (page 32)
Rear bezel (page 49)
Top case (page 52)
Ballast/power supply ECA (page 6)
Chassis (page 12)
Controller ECA (page 19)
Color wheel shield (page 17)
To Next Page
Loading...
