X2 Service Manual 19
4 Turn the projector right side up on the work surface. Gently pull the top of the front bezel away
from the projector. The two tabs and slotted receiver on the front bezel disengage from the
projector. To detach the bezel, hold one hand on the top case. Grasp the bezel where it meets
the lamp door, and then pull it outward until the tabs disengage.
CAUTION Do not pry on the front bezel with a screwdriver.
5 If you are replacing the front bezel, go to the next step. Otherwise, set the bezel aside and
continue with the tear down.
6 Remove the two M3x8 Plastite Phillips screws that fasten the inner grill to the front bezel, then
separate the two parts.
To Next Page
Loading...
