Inovance MD500T75G - Monitoring Function Codes

MD500 User Manual 6. Parameter Table
- 103 -
6.3 Monitoring Function Codes
Function Code Parameter Name Display Range
Group U0: Monitoring Parameters
U0-00 Running frequency 0.00 to 500.00 Hz
U0-01 Frequency reference 0.00 to 500.0 Hz
U0-02 Bus voltage 0.0 to 3000.0 V
U0-03 Output voltage 0 to 1140 V
U0-04 Output current 0.00 to 655.35 A
U0-05 Output power 0 to 32767
U0-06 Output torque -200.0% to 200.0%
U0-07 DI state 0 to 32767
U0-08 DO state 0 to 1023
8 AI1 voltage -
U0-10 AI2 voltage -
U0-11 AI3 voltage -
U0-12 Count value -
U0-13 length value -
U0-14 Load speed display 0 to 65535
U0-15 PID reference 0 to 65535
U0-16 PID feedback 0 to 65535
U0-17 PLC stage -
U0-18 Pulse reference 0.00 to 20.00 kHz
8 Feedback speed -500.0 to 500.0 Hz
U0-20 Remaining running time 0.0 to 6500.0 min
U0-21 AI1 voltage before correction 0.00 to 10.57 V
U0-22 $,YROWDJH9FXUUHQWP$EHIRUHFRUUHFWLRQ 0.00 to 10.57 V
U0-23 AI3 voltage before correction -10.57 to 10.57 V
U0-24 Linear speed WRPPLQ
U0-25 Accumulative power-on time -
U0-26 Accumulative running time -
U0-27 Pulse reference 0 to 65535 Hz
U0-28 Communication reference -100.00% to 100.00%
U0-28 Reserved -
U0-30 Main frequency reference 0.00 to 500.00 Hz
U0-31 Auxiliary frequency reference 0.00 to 500.00 Hz
U0-32 Viewing any register address value -
U0-34 Motor temperature -
U0-35 Target torque -200.0% to 200.0%
U0-37 Power factor angle -180° to 180°
8 7DUJHWYROWDJHXSRQ9)VHSDUDWLRQ 0 V to rated motor voltage
U0-40 2XWSXWYROWDJHXSRQ9)VHSDUDWLRQ 0 V to rated motor voltage
U0-41 DI state display -
U0-42 DO state display -
U0-43 DI set for function state display 1 -
U0-44 DI set for function state display 2 -
U0-45 Fault information -
U0-58
Phase Z counting 0 to 65535
8 Frequency Reference -100.00% to 100.00%
U0-60 Running frequency -100.00% to 100.00%
U0-61 AC drive running state 0 to 65535
efesotomasyon.com