Inovance MD500T75G - Mechanical Installation; Installation Environment

2. Mechanical Installation MD500 User Manual
- 26 -
2. Mechanical Installation
2.1 Installation Environment
Item Requirements
Ambient temperature -10°C to 50°C
Heat dissipation ,QVWDOOWKH$&'ULYHRQDQLQFRPEXVWLEOHVXSSRUWLQJVXUIDFHDQGPDNHVXUHWKHUHLVVXIÀFLHQWVSDFH
DURXQGWKHHQFORVXUHWRDOORZIRUHIÀFLHQWKHDWGLVVLSDWLRQ6HH´0RXQWLQJ2ULHQWDWLRQDQG
Clearance” below. Use strong screws or bolts to secure the enclosure on the supporting surface.
Mounting location Make sure the mounting location is:
ƕ Away from direct sunlight
ƕ Not in an area that has high humidity or condensation
ƕ Protected against corrosive, combustible or explosive gases and vapours
ƕ Free from oil, dirt, dust or metallic powders.
Vibration
ƕ Make sure the mounting location is not affected by levels of vibration that exceed 0.6 g.
ƕ Avoid installing the enclosure near to punching machines or other mechanical
machinery that generates high levels of vibration or mechanical shock.
Protective enclosure 7KH0'XQLWVWKDWKDYHSODVWLFGULYHVPXVWEHLQVWDOOHGLQDÀUHSURRIFDELQHWZLWK
doors that provide effective electrical and mechanical protection. The installation must
conform to local and regional laws and regulations, and to relevant IEC requirements.
Oil, dirt, dust
Direct
sunlight
Strong vibration
High temperature,
humidity
Corrosive, combustible
or explosive gases
Combustible material
efesotomasyon.com