Inovance MD500T75G - Page 197

MD500 User Manual 7. Description of Parameters

Value Function Description
38 Alarm output
If a fault occurs on the AC drive and the AC drive continues to run, the
terminal outputs an alarm signal.
 Motor overheat pending
The terminal set for this function becomes on when the motor
WHPSHUDWXUHUHDFKHVWKHYDOXHVHWLQ)0RWRURYHUKHDWSHQGLQJ
threshold). You can view the motor temperature by using U0-34.
40 Current running time reached
The terminal set for this function becomes on when the current running
time of the AC drive exceeds the value set in F8-53.
41 Fault output
When a fault occurs on the AC drive and the fault is not undervoltage,
the terminal set for this function outputs the ON signal.
Function Code Parameter Name Setting Range Default
F5-17 FMR output delay
0.0s to 3600.0s
0.0s
F5-18 Relay 1 output delay
0.0s to 3600.0s
0.0s
) Relay 2 output delay
0.0s to 3600.0s
0.0s
F5-20 DO1 output delay
0.0s to 3600.0s
0.0s
F5-21 DO2 output delay
0.0s to 3600.0s
0.0s
These function parameters set the output delay of terminals FMR, relay1, relay2, DO1 and DO2 from state change.
Function Code Parameter Name Setting Range Default
F5-22 DI active mode selection 1
0: Positive logic active
1: Negative logic active
00000
Unit's digit: FMR active mode
Ten's digit: Relay1 active mode
Hundred's digit: Relay2 active mode
Thousand's digit: DO1 active mode
Ten thousand's digit: DO2 active mode
This function parameter sets the active mode of terminals FMR, relay1, relay2, DO1 and DO2.
ƕ 0: Positive logic active
The digital output terminal becomes active when being connected with COM, and inactive when being disconnected from
COM.
ƕ 1: Negative logic active
The digital output terminal becomes active when being disconnected from COM, and inactive when being connected with
COM.
efesotomasyon.com