Inovance MD500T75G - Page 258

9. Peripherals and Options MD500 User Manual
- 258 -
([WHQVLRQ&$1OLQN&DUG0'&$1
Ƶ
Overview
MD38CAN1 is designed to connect the MD500 drive to the high-speed CANlink bus. It complies with the CANlink bus standard.
CANlink is based on CAN bus and developed by Inovance. It is an open communication protocol and the equipments supporting
this protocol can be connected to the CANlink bus. The products of Inovance such as AC drive, servo drive, HMI and PLC cal be
connected to the CANlink bus seamlessly.
Ƶ
Physical Appearance
Ƶ
Mechanical Installation
The MD38CAN1 has the same installation mode as the MD38IO2 does.
Ƶ
Description of Terminals and Jumpers
The following table describes the terminals of the MD38CAN1.
Type Terminal Terminal Name Function Description
CAN
communication
terminal
CANH CAN positive input Connect to the positive pole of the CAN bus.
CANL CAN negative input Connect to the negative pole of the CAN bus.
COM Power ground Connect to the reference ground of all CAN nodes.
7KHIROORZLQJWDEOHGHVFULEHVWKHMXPSHUVRIWKH0'&$1
Jumper Description Meaning Setting
J2 CANlink terminal resistor matching selection Matching the terminal resistor
Not matching the terminal resistor
Note
7KHVHWWLQJRIWKHMXPSHUVWDNHVWKHWRSYLHZZLWKWKHPDLQWHUPLQDOVDWWKHERWWRPRI
WKHFDUGDVWKHYLVXDODQJOH7KHMXPSHUVDUHVLONVFUHHQHGRQWKHFDUG
:KHQDSSO\LQJWKH&$1OLQNFRPPXQLFDWLRQFRQQHFWDWHUPLQDOUHVLVWRUWRWKHHQG$&GULYHDQGVKRUWSLQVDQGRIWKHMXPSHU
J2.
efesotomasyon.com