Inovance MD500T75G - Page 60

4. Operations MD500 User Manual
- 60 -
Ƶ
Relevant parameters for operation panel setting
Function Code Parameter Name Setting Range Default
F7-01 MF.K key function selection 0: MF.K key disabled
1: Switchover from remote control (terminal
or communication) to keypad control
2: Switchover between forward rotation and reverse rotation
)RUZDUGMRJ
5HYHUVHMRJ
5: Individualized parameter display
0
F7-02 67235(6(7NH\IXQFWLRQ 67235(6(7NH\HQDEOHGRQO\LQNH\SDGFRQWURO
67235(6(7NH\HQDEOHGLQDQ\RSHUDWLRQPRGH
1
FP-03 Parameter display property )RUXVHUGHÀQHGDQGXVHUPRGLÀHGSDUDPHWHUV
00: non of them will display
XVHUGHÀQHGSDUDPHWHUVZLOOGLVSOD\
XVHUPRGLÀHGSDUDPHWHUVZLOOGLVSOD\
11: both of them will display
00
Ƶ
Status Indicators
There are four red LED status indicators at the top of the operating panel.
Indicator Indication
RUN
OFF indicates the MD500 is in the stop state.
ON indicates the MD500 is in the running state.
LOCAL/REMOT
OFF indicates the MD500 is under the operating panel control.
ON indicates the MD500 is under the terminal control.
FLASHING indicates the MD500 is under the communication control.
FWD/REV
OFF indicates reverse motor rotation.
ON indicates forward motor rotation.
TUNE/TC
ON indicates torque control mode.
FLASHING SLOWLY (once a second) indicates auto-tuning state.
FLASHING QUICKLY (four times a second) indicates a fault condition.
efesotomasyon.com