Integra DTM-5.9 User Manual

21
Turning On the Receiver
For the TAPE and VCR/DVR buttons, the input display
name can be changed in the sequence as shown below.
When the input display name has been changed for one
of the buttons below, the display name for the other
button cannot be changed.
• TAPE button : TAPE→MD→CDR→Dock
• VCR/DVR button : VCR/DVR→Dock
On/Standby
Standby indicator
On/Standby
Turning On and Standby
1
Press the [On/Standby] button.
Alternatively, press the remote
controller’s [On/Standby] button.
The receiver comes on, the display
lights up, and the Standby indicator
goes off.
To turn the receiver off, press the
[On/Standby] button, or press the
remote controller’s [On/Standby]
button. The receiver will enter Standby
mode. To prevent any loud surprises
when you next turn on the receiver,
always turn down the volume before
you turn it off.
or
Receiver
Remote
controller
Changing the Input Display
1
Press the appropriate input
selector button.
The selected input name appears in the
display.
2
Press and hold down the input
selector button selected in the
Step 1 above for approximately 3
seconds to change the display
name.
or

Integra DTM-5.9 Specifications

General

Brand	Integra
Model	DTM-5.9
Category	Stereo Receiver
Language	English