28
Listening to the Radio—Continued
■ Tuning into Stations by Frequency
You can tune into AM and FM stations directly by
entering the appropriate frequency.
Presetting AM/FM Stations
You can store a combination of up to 40 of your favorite
AM/FM radio stations as presets.
■ Selecting Presets
■ Deleting Presets
The receiver changes FM frequency in 0.2 MHz steps,
10 kHz steps for AM.
When tuned into a station, the TUNED indicator
appears. When tuned into a stereo FM station, the FM
STEREO indicator also appears.
Tuning into Weak FM Stereo Stations
If the signal from a stereo FM station is weak, it may be
impossible to get good reception. In this case, switch to
Manual Tuning mode and listen to the station in mono.
1
Press the [Direct Tuning] button.
(Actual display depends on country.)
2
Within 8 seconds, use the
number buttons to enter the
frequency of the radio station.
For example, to tune to 87.5 (FM),
press 8, 7, 5.
1
Tune into the AM/FM station that
you want to store as a preset.
2
Press the [Memory] button.
The Memory indicator appears and the
preset number flashes.
3
While the Memory indicator is
displayed (about 8 seconds), use
the number buttons on the
receiver to select a preset from 1
through 40.
Receiver
Remote controller
Receiver
Remote controller
Memory
Tuning mode
Number buttons
Preset
/
Receiver
Receiver
4
Press the [Memory] button again
to store the station or channel.
The station or channel is stored and the
preset number stops flashing.
Repeat this procedure for all of your
favorite AM/FM radio stations.
1
To select a preset, use the
number buttons on the receiver,
or the remote controller’s Preset
[
++
++
]/[−−
−−
] buttons.
1
Select the preset that you want to
delete.
See the previous section.
2
While holding down the
[Memory] button, press the
[Tuning mode] button.
The preset is deleted and its number
disappears from the display.
Receiver
Receiver
Remote controller
Receiver
AUTOTUNED
FM STEREO
To Next Page
Loading...
