24
Enjoying Audio Sources—Continued
This section explains functions that can be used with any input source.
Adjusting the Bass
The Bass control adjusts bass
sounds. Turn it up to make them
louder. Turn it down to make them
quieter. Normally, it should be set
midway.
Adjusting the Treble
The Treble control adjusts treble
sounds. Turn it up to make them
louder. Turn it down to make them
quieter. Normally, it should be set
midway.
Adjusting the Balance
The Balance control is used to
control the relative volume level of
the left and right speaker systems or
headphones.
Pressing the [Direct] button on the
receiver or pressing the [Direct] button
on the remote controller activates the
Direct function.
To turn the function off, press the
[Direct] button on the receiver or
press the [Stereo] button on the
remote controller.
When the Direct function is off, the tone controls can be
used to adjust the sound.
When the Direct function is on, the tone controls are
bypassed, so you can enjoy a pure sound.
You can configure whether the Direct function is applied
or not for input sources individually.
TrebleBass BalanceDirect
Direct
Stereo
Using the Tone and Balance Controls Setting the Direct Function
Receiver
Remote controller