25
Recording
This section explains how to record the selected input source to a component with recording capability.
You can record an audio signal on a recording
component connected to the TAPE OUT, or VCR/DVR
OUT jacks.
When you want to record the input from the TAPE IN (or
VCR/DVR IN) jacks, you cannot record the sound on a
recording component connected to the TAPE OUT (or
VCR/DVR OUT) jacks.
Note:
The volume, balance, mute and tone controls have no
effect on the signal being recorded.
Unless you have the full consent of the copyright holder, copyright laws prohibit using your
recordings for anything other than personal enjoyment!
Input selector buttons
Recording the Input Source
1
Prepare the recorder:
• Set the recorder so that it’s ready for
recording.
• If necessary, adjust the recording level on the
recorder.
• See the recorder’s manual for more
information.
2
Use an input selector button to select
the component that you want to record
from.
3
Start playback on the component
selected in step 2.
Note:
If you select another input source during
recording, the newly selected input source will
be recorded.
To Next Page
Loading...
Need help?
General
